How To Fit One Of Our Skins
Watch our video here or follow the instructions below.
Step one:
Clean the back of your device using the wet & dry wipes provided. Ensure there is no debris & it is dry.
Step two:
Peel the skin from the white backing film & apply it to the rear of the device from the top to bottom using the squeegee.
Step three:
When fitting the skin, make sure at the top to align it straight & central. If you find the skin is not aligned correctly, you can slowly peel it back and try again. Once fitted, there will be a thin plastic film to peel to reveal the skin.
If the skin is...
..not adhering to the side of the device. Using a hairdryer or heat gun on low heat, apply heat to the skin in a circular motion and then use the squeegee to adhere the skin to the device.
How To Fit Our Screen Protection
Watch our video here or follow the instructions below.
Step one:
Clean the front screen using the included wet & dry wipes provided. Ensure there is no debris & it is dry.
Step two:
Peel the protector from the white backing film and fit to the screen (don’t worry about any bubbles right now).
Step three:
Lift 1 half, then using the squeegee, push away from the middle to apply the protector to the screen. Repeat for the other side then check for any bubbles.
If there are any air bubbles, you can push these out by using the squeegee. Any remaining bubbles will dissipate automatically within 24 hours.
Step four:
Peel the top layer to reveal your fitted protector. Make sure to peel the top layer only and not both layers (the protector itself!)
